1 1

SikaShield W159

SikaShield W159

₱10,700.00
₱10,700.00
Shipping calculated at checkout.

SikaShield® W159 ED 1,5 mm | Wet Applied Bituminous Waterproofing

 

An adhesive bituminous waterproofing membrane wet applied to the concrete surface by the adhesive mortar SikaShield® W1. It has a thickness of 1.5 mm and is flexible at -15 °C. It is reinforced with a cross-laminated PE film, which gives high mechanical properties to the membrane. The top surface and the underside have a removable liner over the adhesive compound for an easy application.

 

Packaging: 1m x 20m / roll

Note: use for adhesive use Sikabit W1

 

Uses / Area of Application

The Product is used as a waterproofing membrane for:

- Basements and other below ground structures

- Vertical reinforced concrete walls 

- Single and strip foundations

 

The Product is used as a:

- Single layer under heavy protection 

- Base sheet in multi-layer systems

Please note: The Product is not suitable for roofs permanently exposed to UV radiation.

OTHERS BOUGHT THIS WITH
Sikabit W-1

₱1,240.00

View full details

Instructions

APPLICATION

1. Unroll the membrane. Align the membrane. Re-roll the membrane before application.

WET APPLICATION
1. Preconditions Before the application of the adhesive mortar, the concrete substrate has been saturated with water. The adhesive mortar SikaBit® W1 has been applied onto the substrate and is still wet.

2. Lay the membrane directly over the wet adhesive mortar. At one end of the membrane, peel away part of the release liner from the membrane's underside.

3. Bond this end of the membrane to the adhesive and the substrate.

4. Continue to peel away the release liner sideways from the rest of the membrane's underside.

5. Bond the rest of the membrane to the adhesive and the substrate.

IMPORTANT
1. If the ambient temperature is below +10 °C, seal the membrane overlaps by heating them with a gas torch or with hot air.

2. Seal the membrane overlaps to avoid trapping the adhesive under the overlap, which can compromise the adhesion.

3. Roll the surface of the applied membrane with a roller from the centre to the edge to remove any air bubbles.

4. Push any excess of adhesive towards the opposite direction of the sealed side overlap. Allow the adhesive mortar to cure for at least 24 hours at +25 °C before you start backfilling.

DETAILING
1. Use a sharp knife to cut in all details such as internal and external corners, upstands, vent pipes, drains, support metalwork etc.

Refer to the relevant method statement for further information on detailing.

Payment & Shipping

FOR PAYMENT:
(1) Paymongo: Mastercard, VISA, GCash, Maya, Grab Pay
(2) Online Bank Transfer to our BDO, Metrobank, and BPI accountsFor more details, kindly check Accepted Modes of Payment

FOR SHIPPING:
(Customer Location) in Metro Manila (NCR)

(1) Rush – Same day Pick-up
(2) Regular Pick-up
(3) Pick-up/Delivery via Third Party*
(4) Delivery to Site locations in Metro Manila**
Lalamove/ Grab Pin: LPM Construction Supply and Wood Center Corporation


(Customer Location) in Pangasinan

(1) Rush – Same day Pick-up
(2) Regular Pick-up
(3) Pick-up/Delivery via Third Party*
(4) Delivery to Site locations in Pangasinan**
Lalamove/ Grab Pin: LPM Construction Supply PangasinanBrgy, Tayug-San Quintin Rd. Tayug,
Pangasinan, PH