SUBSTRATE PREPARATION

All surfaces to be coated should be thoroughly cleaned by conventional means. The substrate must be clean and free from all contaminants such as dirt, oil, grease, coatings and surface treatments, etc.

Steel is ideally prepared by shot blasting to Sa 2½ or SSPC 10 (nearly white metal). Where blasting is not permitted then clean metal preparation by power tools is acceptable.

Non-ferrous metals are prepared by removing deposits of dust and oxidation and abrade to white metal. Wire brushing can be used on soft metals, i.e. copper.

Concrete substrates must be prepared mechanically using abrasive blast cleaning or scarifying equipment to remove cement laitance and achieve an open textured surface.

Weak concrete must be removed and surface defects such as blowholes and voids must be fully exposed.

Repairs to the substrate, filling of blowholes/voids and surface levelling must be carried out using appropriate products from the Sikafloor®, Sikadur® and Sikagard® range of products.

Concrete or screed substrate has to be levelled in order to achieve an even surface. High spots must be removed by e.g. grinding.

Ensure that surfaces are free from visible dampness and that all dust, loose and friable material is completely removed from all surfaces before application of the product, preferably by brush and/or vacuum.

MIXING

Prior to application, stir Sikalastic®-1 C Primer PU gently but thoroughly for 1 minute in order to achieve a homogeneous mixture.

For mixing, an electric single paddle mixer (300–400 r.p.m.) with a spiral blade can be used. Over mixing must be avoided to minimize air entrainment.

APPLICATION

Prior to application, confirm substrate moisture content, r.h. and dew point.

Make sure that a continuous, pore free layer covers the substrate. If necessary, apply two priming coats.

Apply Sikalastic®-1 C Primer PU by brush or roller.

Consumption is depending on the porosity of the substrate, ranging between 100–500 g/m² in one or two coats.

On existing Sikalastic® system the consumption must be maximum 100 g/m² in one coat.

FOR PAYMENT:
(1) Paymongo: Mastercard, VISA, GCash, Maya, Grab Pay, Billease (Installment)
(2) Online Bank Transfer to our BDO, Metrobank, and BPI accountsFor more details, kindly check Accepted Modes of Payment

You'll have a dedicated truck or motorcycle per order, straight to your site. One fee covers the full load, so order big and save on every trip.

(Customer Location) in Metro Manila (NCR)

(1) Rush – Same day Pick-up
(2) Regular Pick-up
(3) Pick-up/Delivery via Third Party*
(4) Delivery to Site locations in Metro Manila**
Lalamove/ Grab Pin: LPM Construction Supply and Wood Center Corporation

(Customer Location) in Pangasinan

(1) Rush – Same day Pick-up
(2) Regular Pick-up
(3) Pick-up/Delivery via Third Party*
(4) Delivery to Site locations in Pangasinan**
Lalamove/ Grab Pin: LPM Construction Supply PangasinanBrgy, Tayug-San Quintin Rd. Tayug,
Pangasinan, PH